Installation; Connecting The Usb Cable - BadgePass NXT5000 User Manual

Document History

1-3 Installation

1-3a Connecting the printer
Connection to the power supply
The printer must be connected to a properly protected and grounded electrical installation.
1.
Connect the power cable to the power supply unit, then plug the power supply unit connecting into the printer.
2.
Next, plug the end of the power cable into an earthed power socket.
3.
The printer will power on: the control panel lights up showing that the printer is working properly. If the control panel does not light, then either
installation has not been carried out correctly or the printer is not working properly. Check the installation.
Before attempting any maintenance, ensure that the power cable is unplugged. For your personal safety, ensure that the cable and power supply unit
remain accessible, especially in the event of an emergency.
To save energy, the printer will automatically switch itself to standby mode after 10 minutes of inactivity. The printer switches to hibernation mode after
30 minutes in standby mode. The standby times can be configured in the BadgePass Print Suite. In standard standby mode, sending a print request
restarts the printer and quickly pressing the pushbutton (for 1 second) will exit the printer from hibernation mode.

Connecting the USB cable

Under no circumstances should you connect the USB data cable before installation of the printer driver is complete.
Refer to the section on printer driver installation for further details, and follow the instructions carefully.
BadgePass NXT5000 USER GUIDE
Page 7