3-3B Servicing The Print Head - BadgePass NXT5000 User Manual

Document History

3-3b Servicing the print head

Recommended cleaning cycle: every 5 routine cleaning cycles. Servicing accessory: cleaning pen
Unplug the printer from its power supply before cleaning the print head. All cleaning cycle procedures must be followed to ensure long life of the printer's
components. Avoid any contact between the print head and any metal or sharp objects. Avoid touching the print head directly with your fingers, as this
could affect print quality or permanently damage the print head.
The cleaning pen can be used up to 8 times for cleaning the print head.
Follow the procedure below:
1.
Remove the cover from the cleaning pen.
2.
Unplug the power supply cable, open the cover, and then find the print head.
3.
Gently rub the pen from left to right along the print head for a few seconds.
4.
Close the cover. Reconnect the printer.
1
Wait for 2 minutes after cleaning before using your printer.
2
BadgePass NXT5000 USER GUIDE
4
3
Page 30