Yanmar 1GM User Manual page 182

176
SEAWATER PUMP
(3HM AND 3HM35 MODELS)
CHAPTER EIGHT
3
6
7
8 5
1. Nut
2. Washer
3.
Pulley
4. Snap ring
5.
Bearings
6. Snap ring
7.
Shaft
8. Key
9.
Cover
10. Washer
8. Press the bearings from the pump shaft using a univer-
sal press plate and arbor press. Force each bearing away
from the locating snap ring (6, Figure 28).
9. Extract or push out the seal (11, Figure 28).
10. Clean all metal components solvent, then dry them
with compressed air.
11. Thoroughly clean all gasket material from all mating
surfaces.
12. Inspect the pump shaft for grooves in the seal contact
area.
13. Inspect the impeller for cracked blades or excessive
wear at the tips of the blades. Replace the impeller if any
defects are observed.
14. Inspect the pump body and cover for grooves or other
damage. A damaged or excessively worn body or cover
will reduce pump efficiency and may damage a new im-
peller.
15. Install the shaft seal (11, Figure 28) so the lip is to-
ward the impeller side of the pump body.
16. If removed, install the snap ring (6, Figure 28) into
the groove in the impeller shaft.
11. Seal
12. Pump body
13.
Fitting
14. Cam retaining
screw
15.
Cam
16.
Impeller
17. Gasket
18.
Cover
19. Screw
17. Press the shaft bearings onto the pump shaft until
fully seated against the snap ring. Press only on the bear-
ing inner races.
18. Install the bearing cover (9, Figure 28) with the con-
cave side toward the bearing.
19. Install the washer (10, Figure 28) onto the shaft.
20. Install the shaft assembly into the pump body. Install
the snap ring (4, Figure 28).
21. Install the slotted washers (2, Figure 28), pulley (3)
and nut (1), then tighten the nut.
22. Install the impeller drive key (8, Figure 28) in the slot
in the impeller shaft.
NOTE
Replace the pump impeller anytime it is re-
movedfrom the pump.
If
the original impel-
ler must be reused, be sure to install it in the
same rotational direction as originally in-
stalled.
23. Lightly lubricate the tips and sides ofthe impeller. In-
stall the impeller into the pump body by rotating the im-