Glass Panel Assembly - Heatilator ICON60IT Owner's Manual

I. Glass Panel Assembly
Removing/Replacing Glass Assembly
• Remove decorative screen front. Disengage spring pins
located at upper right and left corners between screen
and frame by pulling down.
Tilt top of frame away from appliance and lift up and out
of bottom slots.
• Remove three outer refractory pieces as per instructions
in Section J.
• Release glass latches (six in ICON60I, ten in ICON100I).
Lift glass frame assembly carefully off bottom glass
support and set aside.
• Reverse steps above to replace the glass assembly.
Left Side
Refractory Panel
Figure 12.10 Glass Panel Assembly Removal/Replacement
38
(See Figure 12.10)
Glass Latch
Front Hearth Refractory
Decorative Screen Front
Heatilator • ICON DV • 4042-300 Rev R • 06/07
Glass Frame Assembly
Right Side Refractory Panel