Install Fixed Glass Assembly; Install Decorative Barrier Front - Heatilator NBV30-IFT Installation Manual

E. Install Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Replacing Fixed Glass Assembly
• Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
Latches
(both bottom
and top)
Glass
Assembly
Figure 12.2 Fixed Glass Assembly
DO NOT PLACE LAVA ROCK OVER
SLOTS IN BASEPAN
MINERAL WOOL OR LAVA
ROCK (IF DESIRED)
FRONT BURNER
PORT HOLES
Figure 12.3 Placement of Mineral Wool, Lava Rock and Vermiculite
32
Heatilator • NBV30-IFT, NBV33-IFT, NBV36-IFT, NBV42-IFT Installation Manual • 2624-980 Rev. E • 10/20
REAR BURNER
PORT HOLES
LAVA ROCK AND VERMICULITE
F. Install Decorative Barrier Front
WARNING! Risk of Fire! Install ONLY doors or fronts
approved by Hearth & Home Technologies. Unapproved
doors or fronts could cause fireplace to overheat.
DO NOT operate the applaince with the barrier removed.
Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install
one.
For more information refer to the instructions supplied with
your decorative barrier front.
DO NOT PLACE LAVA ROCK OVER
MINERAL WOOL
SLOTS IN BASEPAN
MINERAL WOOL OR LAVA
ROCK (IF DESIRED)