Toro Workman MDX-D Service Manual page 75

1. Cable bracket
NOTE: Keep the gasket sealing surfaces of the cases
as horizontal to each other as possible. If the sealing
surfaces do not join to each other, tap the case lightly
with a plastic hammer.
C. Install case (RH) so each shaft fits properly into
the case.
1. Axle bracket
F. Position axle bracket to each axle case. Secure
axle bracket to each axle case with flange bolts.
Torque bolts from 25 to 31 ft- -lb (34 to 42 N- -m).
Workman MDX--D
1
Figure 55
Figure 56
Page 4 - - 41
15 to 18 ft- -lb
2
(21 to 25 N- -m)
2. Flange bolt
D. Position cable bracket to transaxle cases.
E. Secure case (RH) to case (LH) with flange bolts
and nuts. Torque bolts from 15 to 18 ft- -lb (21 to 25
N- -m).
25 to 31 ft- -lb
(34 to 42 N- -m)
2
1
2. Flange bolt
Drive Train