Toro Workman MDX-D Service Manual page 60

1. Differential assembly
2. Input shaft assembly
IMPORTANT: Make sure to not damage the oil seal
when removing the input shaft.
NOTE: If any of the assemblies can not be pulled out by
hand, hold the assembly while gently tapping the case
with a plastic hammer. Make sure to tap equally around
the case.
3. Remove axle case from case (RH and LH).
1. Flange bolt
2. Axle case
A. Remove remaining two (2) flange bolts securing
each axle case to the case. Remove axle case from
the transaxle case.
Drive Train
3
4
2
1
Page 4 - - 26
Figure 28
3. Center shaft assembly
4. Shift shaft
G. Lift up differential assembly, center shaft assem-
bly and input shaft assembly at the same time. First,
remove input shaft assembly. Then, remove center
shaft assembly with the shift shaft and differential as-
sembly.
Figure 29
3. Transaxle case
1
2
3
Workman MDX--D