Toro Workman MDX-D Service Manual page 58

1. Case (RH)
IMPORTANT: Make sure to not hit the governor
boss too hard when separating the cases, the boss
may get damaged. Do not pry open the two cases
with a screw driver, damage may result to the seal-
ing surfaces.
2. Remove input shaft, center shaft and differential assemblies.
1. Gasket
A. Remove gasket and pipe knocks.
Drive Train
1
Figure 24
Figure 25
Page 4 - - 24
2. Governor boss
G. Hold the case (RH) and lift up while lightly tapping
the governor boss with a plastic hammer.
2. Pipe knock
2
2
1
Workman MDX--D