Toro Workman MDX-D Service Manual page 61

1. Snap ring
2. Axle case
IMPORTANT: Do not reuse snap ring. Discard and
replace ring with new one.
B. Remove snap ring from the axle case. Remove
axle shaft from case.
IMPORTANT: When replacing ball bearings, both
ball bearings must be replaced as a set.
4. Disassemble input shaft assembly.
1. Ball bearing
IMPORTANT: Do not reuse ball bearings that have
been removed.
Workman MDX--D
2
4
3
1
Figure 30
3. Axle shaft
4. Ball bearing
C. Ball bearing roller balls must be free of deforma-
tion and scoring. Ball bearing must spin freely and
have minimum axial play. Replace ball bearing as
necessary.
1
Figure 31
2. Input shaft
A. Remove ball bearing from the input shaft with a
bearing puller.
Page 4 - - 27
2
Drive Train