Toro Workman MDX-D Service Manual page 71

4. Install axle case to case (RH and LH).
1. Axle shaft
2. Snap ring
IMPORTANT: Do not reuse snap ring. Replace snap
ring with new one.
25 to 31 ft- -lb
(34 to 42 N- -m)
1. Axle case
2. Case
IMPORTANT: Make sure to install the axle case to
the proper side of the case. The right side of the
case takes the short axle case, and the left side
takes the long axle case.
IMPORTANT: Make sure to not damage the oil seal
when installing the axle case to the case.
Workman MDX--D
3
Figure 47
3. Ball bearing
3
Figure 48
3. Flange bolt
Page 4 - - 37
2
1
A. Insert axle shaft with snap rings, collar and ball
bearings into the axle case. Install snap ring to the
axle case.
1
B. Install axle case to the case. Secure each axle
case to the case with flange bolts. Torque bolts from
25 to 31 ft- -lb (34 to 42 N- -m).
2
Drive Train