Toro Workman MDX-D Service Manual page 33

4. Connect the following electrical components:
A. Connect main wire harness connections to glow
plug bus, temperature sender and engine run solen-
oid (Fig. 14).
B. Connect main wire harness connection to fusible
link harness.
C. Connect engine wire harness connector to the
main wire harness.
D. Secure negative battery cable and engine ground
connector to front engine mount with flange head
screw. The order of assembly should be lock washer,
negative battery cable, engine ground connector
and then flange head screw. Coat connectors with
skin over grease or terminal protector (see Special
Tools in Chapter 5 -- Electrical System) after as-
sembly.
5. Install drive belt to drive clutch.
IMPORTANT: Make sure to remove all plugs and
covers that were placed on hose and engine open-
ings during engine removal.
6. Connect fuel supply hose to the injector pump and
fuel return hose to the #2 injector.
7. Position throttle cable to engine. Secure the throttle
cable end to injector pump speed control lever with
shoulder bolt and flange nut. Tighten cable nuts to se-
cure cable to cable mount (Fig. 13). Check throttle cable
adjustment (see Adjust Throttle Cable in the Adjust-
ments section of this chapter).
Workman MDX--D
8. Install exhaust header and muffler to the vehicle (see
Exhaust System in this section).
9. Install air intake hose to the air cleaner and engine
intake (see Air Cleaner in this section).
10.Connecting lower and upper radiator hoses to the ra-
diator. Fill cooling system with coolant (see Radiator in
this section). Check radiator and hoses for leaks.
11. Make sure that alternator belt tension is properly ad-
justed.
12.Check that the gap between the rubber bumper and
front engine bracket is 0.090" (2.2 mm) (Fig. 16). If gap
is incorrect, loosen three (3) lock nuts and adjust bump-
er to provide correct gap. Tighten lock nuts to secure
bumper after adjustment.
13.Make sure engine oil level is correct.
14.Install cargo box to the frame (see Cargo Box in the
Service and Repairs section of Chapter 6 -- Chassis).
15.Connect positive (red) cable to the battery. Then,
connect negative (black) cable to the battery.
Page 3 - - 17 Diesel Engine