Streaming Function; Setting The Network Connection; Using The Streaming Function; List Of System Modes And Supported Streaming Output - Panasonic AJ-PX270 Operating Instructions Manual

Hide thumbs Also See for AJ-PX270:
Table of Contents

Advertisement

Streaming function

You can perform live streaming of audio and video from the camera over the network (wired LAN, wireless LAN, 4G/LTE).
Streaming video from the camera or an application software (e.g. P2 Browser, P2 Streaming Receiver) of a device connected to the camera through a
network is transmitted to a server capable of receiving such signal.
There are two ways to start streaming: streaming from an application software and streaming from the camera.
@
NOTE
t To display the streaming video in the P2 Browser, start the streaming distribution by operation from the application software. The streaming video
cannot be displayed when operated from the camera.

Setting the network connection

The network settings of the camera are configured according to the settings of application software.
For details on the network connection when starting streaming from the camera or an application software such as P2 Streaming Receiver, refer to
"Connection settings for the streaming function" (page 188).

Using the streaming function

After you finish configuring the network connection, you can configure the streaming function.
1
Select [STREAMING] in the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [CODEC USAGE].
Streaming function is enabled.
2
Set the streaming mode in the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [STREAMING MODE].
f Select either [LOW], [HQ], [AVC-G6], [SHQ (QoS)], or [AVC-G (QoS)].
f For details on combinations of system modes and streaming modes, refer to the table in "List of system modes and supported streaming output"
(page 89).
3
Set the method for starting streaming.
f When starting streaming through operation from an application software
- Select [RECEIVER] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START TRIGGER].
f When starting streaming through operation from the camera
- Select [CAMERA] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START TRIGGER].
- Perform following settings when the streaming mode is set to [SHQ (QoS)] or [AVC-G (QoS)] in Step
Set the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [QoS MAX RATE] and [QoS MIN RATE].
- Set the delay mode during live streaming in the main menu → [RECORDING SETUP] → [DUAL CODEC SETTING] → [STREAMING LATENCY].
Set to [NORMAL] if you want to emphasize the stability of streaming. Set to [SHORT] if you want to emphasize the reduction of streaming delay.
4
Start streaming.
f When starting streaming through operation from an application software
If you started streaming using an application software, the camera starts the transmission of streaming video.
f When starting streaming through operation from the camera
Select [ON] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START].
If the camera is connected to the transmission destination through a network, the camera starts the transmission of streaming video.
To stop the transmission of streaming video, select [OFF] in the main menu → [NETWORK SETUP] → [STREAMING SETTING] → [START].
@
NOTE
t To display streaming video using the P2 Browser, VLC Media Player is required for Windows OS and QuickTime Player is required for Mac OS.
However, the P2 Browser does not support the QoS function.
t For details on downloading application software which supports video streaming and the operating environment, visit the support desk at the following
website:
http://pro-av.panasonic.net/
t The streaming function cannot be used together with the dual codec recording, simultaneous recording, and background recording.
t The streaming function cannot be used together with the rec during upload function.
t If available bandwidth of the network is low and streaming playback is interrupted, this can be improved by selecting a lower bitrate mode in
[STREAMING MODE], or selecting either [SHQ (QoS)] or [AVC-G (QoS)]. In addition, if [SHQ (QoS)] or [AVC-G (QoS)] is selected, the terminal that
receives streaming data needs to support the QoS function.
t The streaming video from the camera will be a black screen in the thumbnail mode and playback mode (including the recording check).

List of system modes and supported streaming output

The following shows the relationship between system modes and streaming modes on this camera.
f "l" are supported, and "—" are not supported.
[SYSTEM MODE]
[LINE&FREQ]
[1080-59.94i]
Chapter 4 Shooting — Streaming function
[REC FORMAT]
[AVC-I100/60i]
[AVC-I50/60i]
[AVC-G50/60i]
[AVC-G25/60i]
– 89 –
2
.
[STREAMING MODE]
HD streaming
[AVC-G6], [AVC-G (QoS)]
l
l
l
SD streaming
[HQ], [LOW], [SHQ (QoS)]
l
l
l
l

Advertisement

Table of Contents
loading

Table of Contents