Panasonic AJ-PX270 Operating Instructions Manual page 88

Error displays
(viewfinder screen)
[SD 0 min] Recording of the materials and proxy data will continue.
f The remaining SD memory card capacity is getting low.
[SD END] Proxy data recording to the SD memory card will stop, but
recording to the P2 card will continue.
f No SD memory card capacity remains.
[SD WR ERR] Proxy data recording to the SD memory card will stop, but
recording to the P2 card will continue.
This is displayed when proxy data cannot be recorded in the
SD memory card even though [PROXY REC(P2&SD)] is set
in main menu → [RECORDING SETUP] → [DUAL CODEC
SETTING] → [CODEC USAGE].
r If the error message is displayed when recording
f The SD memory card format is different.
f The SD memory card contains 1000 clips or more.
r If the error message is displayed during
f The SD memory card was ejected during recording.
f An error occurred in recording to the SD memory card.
[SD --min] or [SD WP] Proxy data will not be recorded to the SD memory card, but
recording to the P2 card will be performed.
f No SD memory card is inserted. [SD --min]
f The SD memory card is write-protected. [SD WP]
Copying proxy data to the SD memory card
1
Press the <THUMBNAIL> button to display the thumbnail screen.
2
Use the control stick to move the cursor to the clip to be copied and press the control stick.
3
Select [SD CARD] in the main menu → [CLIP] → [COPY].
4
Select [YES] in the confirmation message and press the control stick.
@ NOTE
t If [SD END] is displayed and the proxy data being recorded to the SD memory card is deleted, perform this procedure to copy the proxy data from the
P2 card, and enable the deleted proxy data to be restored.
t Source data is not copied.
Chapter 4 Shooting — Dual codec recording
Behavior and cause
(approximately shorter than one minute)
starts:
recording:
After finishing recording, insert a new SD memory card.
After finishing recording, insert a new SD memory card.
f The proxy data being recorded to the SD memory card will
be deleted.
To restore the deleted proxy data, select clips in the P2 card
and copy them to the SD memory card. (page 88)
Check the status of the SD memory card and insert a
recordable card. (page 86)
Check the status of the SD memory card.
– 88 –
Action to take