Oki C911 Maintenance Manual page 72

Oki Data CONFIDENTIAL
LCD Status Message Online
Inspection
lamp
indicator
( represents a blank line.)
Varies On
%COLOR% Toner (Blink)
Low Off
Varies On
Non OEM
%COLOR% Toner
Detected
45530603TH Rev.2
Details
Indicates that amount of toner is low.
When the MENU button > [Menus] >
[System Adjust] > [Low Toner] is set to
[Stop], the inspection LED blinks, and
the printer goes into offline.
When the OK button is pressed, or
when a specific error is cleared, the
printer exits the offline mode and
continues printing until TONER EMPTY
is detected.
A specific error is one of errors from
Priority 300 to 380.
If a TONER LOW error has occurred
when the power is turned on and also
the MENU button > [Menus] > [System
Adjust] > [Low Toner] is set to [Stop], the
inspection LED blinks, a beep sounds,
and the printer goes into offline at the
timing when initialization is completed.
By pressing the OK button, the printing
can continue until TONER EMPTY is
detected.
When [Admin Setup] > [Panel Setup] >
[Near Life LED] is set to [Disable], the
inspection LED stays out.
%COLOR%
Yellow
Magenta
Cyan
Black
White
Clear
Indicates detection of a toner cartridge
not suitable for this printer.
%COLOR%
Yellow
Magenta
Cyan
Black
White
Clear
Remedial
LCD Status Message Online
measure indicator
( represents a blank line.)
– Varies
Incompatible
%COLOR% Toner
Varies
Non Genuine
%COLOR% Toner
Varies
%COLOR% Image
Drum Sensor Error
Prompts
the user
to use an
Varies
optimal
toner Non Paper Sense
cartridge. Error
Varies
Paper Sense Error
4. TROUBLESHOOTING PROCEDURE
Inspection
Details
lamp
On Indicates detection of a toner cartridge
not suitable for this printer.
%COLOR%
Yellow
Magenta
Cyan
Black
White
Clear
On Indicates detection of a toner cartridge
not suitable for this printer.
%COLOR%
Yellow
Magenta
Cyan
Black
White
Clear
On Something is wrong with the toner sensor.
%COLOR%
Yellow
Magenta
Cyan
Black
White
Clear
This warning message is displayed
only in the Shipping mode. Alternatively
an error from 5400 to 5405 may
appear depending on the PU detection
conditions. In the Factory mode, a
service call from 163-01 to 163-05
appears instead.
On The sensor output value at paper out is
out of spec. (zero point correction error).
When this error occurs, execute printing
by setting Media Weight to Medium.
On The sensor output value difference
is out of spec. (thickness beyond the
detection limit).
When this error occurs, execute printing
by setting Media Weight to Medium.
Remedial
measure
Prompts
the user
to use an
optimal
toner
cartridge.
Prompts
the user
to use an
optimal
toner
cartridge.
If the image
drum is
fixed with
a stopper,
remove it.
Lightly wipe
the image
drum
sensor lens
surface
with a dry
soft tissue.
–
–
4-27