Table of Contents
Advertisement
Included Software Setup
Alarm Monitor Overview
Installing the Alarm Monitor
Configuring the DVR
________________________________________________________________________________________________________
130
The Alarm Monitor software is a utility that streams video across a Local Area Network
to a Client PC when an alarm is detected on the DVR. The video that streams across
can be stopped, played forwards and backwards, in slow motion or real time.
The utility is loaded at startup and placed in the taskbar. It constantly monitors for a
signal from the DVR. When an alarm signal is detected the Alarm Monitor Image
Viewer Window opens and starts playing the video from the camera associated to the
alarm.
1.
Insert the Software Installation Disc into the CDROM. (Do not install on the DVR)
Select the Alarm Monitor option to begin installation and accept the license
agreement.
2.
Follow the on screen instructions.
Click the Finish button to complete the installation.
3.
To enable the Alarm Monitor on the DVR follow these steps:
Enter Setup and click the Recording Schedule tab.
1.
2.
Assign the desired sensors to the desired cameras. Refer to the Recording
Schedule section of this manual for in depth instructions on how to do this.
Enable Sensor Event and/or Motion Event in the Alarm Options Section of each
3.
schedule number to send alarm events to the Alarm Monitor.
The Remote Alarm and Emergency Alarm options are used by the more
Note
advanced FVMS multi site management and control software.
4.
Enter the IP Address of the computer running the Alarm Monitor software.
5.
Click the Network tab and make sure that Disable Remote Control is not checked.
The Alarm Monitor uses the Emergency Port to transfer the data through. The port
6.
can be adjusted inside the Network Menu if necessary. It is recommended that the
default port setting be used.
7.
Click the Sensor Menu tab.
Configure the Sensors assigned to cameras.
8.
Click OK.
9.
Document 900.0803 Rev 7
02/29
Advertisement
Table of Contents
