Frame Setup - Honeywell FUSION III DVR User Manual

Frame Setup

________________________________________________________________________________________________________
Document 900.0803 Rev 7
02/29
The Frame Setup Menu gives the user the option to adjust both the resolution and the
number of images per second each camera will record. When setting up the IPS
sliders, the BLUE slider represents the frames at which the DVR will capture the
incoming video while the RED slider represents the frame rate that will be recorded.
This option is beneficial when higher frame rates are desired remotely. The Server will
only send out frames remotely that have been first encoded. For Ex. If the Blue
'ENCODING' option is set to 25 IPS and the Red 'RECORDING' option is set to 7 IPS
then the DVR Server will record 7 IPS and users viewing live video remotely will receive
25 IPS on that specific camera. Please note that there are different frame setup
windows for Real Time and non Real Time models.
The Software will not allow the maximum available Frames to be exceeded.
Note
The RED IPS record slider cannot exceed the BLUE IPS capture slider.
Note
Frame Select Blue Slider: Sets the IPS recorded during intensive recording and
available for viewing on a remote client PC.
Red Slider: Sets the IPS recorded by the DVR during normal
recording.
Video Quality Lower quality video has a smaller file size but appears more
pixilated.
Sensitivity Sets the Keyframe refresh rate. Adjusting this setting can have
negative effects on video quality. NOTE: Do not change the default
setting unless instructed by a system administrator.
Resolution Affects the total number of frames per second that are available.
Fusion III DVR User Guide
41