Zone Descriptions; Date; Time - NAPCO Gemini GEM-P816 Programming Instructions Manual

ZONE DESCRIPTIONS (GEM-RP1CAE2 / GEM-K1CA KEYPADS)
(Direct Entry)
01-
PRESS: CHARACTERS DISPLAYED
IN SEQUENCE
[1]
ABC1
[2]
DEF2
[3]
GHI3
[4]
JKL4
[5]
MNO5
[6]
PQR6
[7]
STU7
[8]
VWX8
[9]
YZ90
[0]
(SPACE) • - . ( ) , / : ? #
Press [ ] to move cursor right.
R
Press [ ] to move cursor left.
B
Notes:
1. After releasing the number button for 2 seconds, the character will be accepted and the cursor advanced to the
right.
2. After releasing the number button, if a new number button is pressed before the 2 second window expires, the cur-
rent character will be accepted and the cursor automatically advanced to the right. The first of the 4 characters of
this new number button will be displayed.
3. To erase an existing entry, use [
new character to overwrite the old, or press zero to delete the character.
4. To generate lowercase characters, the [
button. If the
G
U
Press to save.
To advance to the next zone (or to any other zone), move the cursor to the displayed zone number (i.e., "01") using
and . Change the zone number using keys
R B
(after entering the first digit, the cursor will automatically advance to the second digit). When the second zone number
digit is entered, the cursor will automatically advance to the right, allowing the description locations to be entered.
U
Always press to save each zone description.
Enter Date
( / / )
(Direct Entry)
Enter Time
( : )
(Direct Entry)
NOTE: To enter the date and time, GEM-RP1CAe2/GEM-K1CA keypad (version 9A or greater) must be used and "Enable
Keypad Time/Date Display" (Address 1420) must be enabled.
NAPCO Security Systems
R
Enter an identifying description for each zone. Characters are selected by
pressing keypad buttons multiple times, "Cell Phone" style. Buttons
through
9
HOLD G
AND PRESS:
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[0]
] or [
R B
] button must be pressed and held down while pressing the number
G
button is released during the 2 second window, the current character will change to uppercase.
Enter Date (Press the
Enter the current date in the format MM/DD/YY, where MM = the month (01–12);
DD=the day (01–31); and YY=the year. Press
proceed.
Enter Time (Press the
Enter the current time in the format HH:MMA/P, where HH=hours (01–12);
MM=minutes (00–59). Select AM or PM by pressing any number button, then press
once again to save.
plus and are used, as per the following table:
0 G
CHARACTERS DISPLAYED
IN SEQUENCE
abc1
def2
ghi3
jkl4
mno5
pqr6
stu7
vwx8
yz9
0
(Reserved)
] to move the cursor below the character to be changed. Enter a
through
0 9
button to set cursor.)
R
button to set cursor.)
R
. Enter two digits for the zone number
U
to save. Press NEXT button to
GEM-P816 Programming Instructions
Page 39
1
U