Advertisement
*
Note: Refer also to the instructions included with the aftermarket radio.
1
Mount the ISO Brackets to the head
unit with the screws supplied with
the unit. (Figure A)
2
Slide the head unit into the radio
opening until the side clips engage.
Snap the Trim plate into the Radio
Housing. (Figure B)
NOTE:
When reinstalling the screws
into the bottom of the 99-7864
use the (2) supplied Phillips
screws instead of the factory
screws removed in step 5 in
Dash Disassembly.
Continue to final assembly.
Programming:
In order to adjust the 99-7864 to
the different types of radios
available in the Honda Accord,
the 99-7864 has a program
feature.
4 DOOR SEDAN ONLY:
To program the kit you will need
to start your vehicle then hold
the A/C button for approximately
5 seconds or until the light starts
to blink.The climate controls will
be programmed when the light
stops blinking.
2 DOOR COUPE ONLY:
To program the kit you will need
to start your vehicle then hold
the Rear Defrost button for
approximately 5 seconds or until
the light starts to blink.The cli-
mate controls will be pro-
grammed when the light stops
blinking.
99-7864 KIT ASSEMBL Y
ISO RADIO PROVISION
A
B
Note:
The orange wire coming out of
the back of the 99-7864 needs to
be connected to the orange illu-
mination wire coming from the
Metra 70-1721 wire harness (sold
separately).
4
Advertisement
