Connect The Sorter Connector - Sharp SF-2030 Service Manual

12. Connect the sorter connector.

Remove the sorter connector cover securing screw which is mounted
to the rear cabinet panel of the copier and remove the sorter connec-
tor cover.
Connect the sorter connector to the connector on the copier and
secure it using the sorter connector securing screw.
Sorter connector cover
Securing screw
Sorter connector
Plug the copier into a grounded outlet and turn the
power switch on.
Then, follow the procedure below.
13. Set the mode.
•
Operate the copier keys to set the mode.
0/
C
The above key operation will display the currently set mode.
•
When only the SF-S18 is to be set, immediately after the above
key operation, operate the keys as follows:
1 0/
•
If the mode is to be set in combination with other options, use the
table shown below to add up the total of the setting values for all
the peripheral devices to be set, and set that total value.
For example, if the SF-S18 and RADF are to be set, the total
setting value is 1 + 10 = 11.
Operate the keys as follows:
1 1
RADF 1 Stand/paper drawer
ADF 1
Securing screw
2 6
0/ 1
4 SF-S18 10
(6) SF-S15 (20-Bin Sorter)
SF-S15
Parts list
Sorter seat
Sorter seat mounting
screws A (2 pcs.)
Unplug the copier and follow the procedure below.
1. Install the support guide.
Hook the pawls (two locations) of the support guide to the inside of
the copier paper exit end to install the guide as shown in Fig.
5 – 27
Support guide
Sorter seat mounting
fixture (1 pc.)
Sorter seat mounting Bracket mounting
screws B (1 pc.) screws B (2 pcs.)
Support guide