Re-Insert The Paper Cassette - Sharp SF-2030 Service Manual

14. Re-insert the paper cassette.

Lift up on both sides of the back of the paper cassette and, while
aligning the right guide on the cassette with the guide rail as shown in
the figure, push the cassette into the desk along the guide rails.
After doing this, confirm that the cassette moves in and out smoothly.
15. Place the paper in the cassette.
Place the paper in the paper cassette.
When doing this, do not stack the paper higher than the maximum
height line indicated on the cassette.
Next, push the cassette all the way into the desk as far as it will go.
Maximum height line
16. Set the mode.
•
Operate the keys on the copier to set the mode.
INTERRUPT INT ERRUPT
C 0 /
The above sequence of key operations will display the current
setting value.
•
If only the SF-D20 is being set, immediately after the above key
operation sequence, perform the following key operation sequence
to set the mode.
READY
0 / 4
Guide rail
Guide
READY
2 6
READY
0 / 1
•
If the mode is to be set for a combination of optional equipment,
add together the setting values shown in the table below for each
peripheral device, and set the mode to the total setting value.
For example, to set the mode for a combination of the SF-D20 and
the SF-S53, the total setting value is 4 + 10 = 14, so the key
operation sequence is as follows.
1 4
SF-A17/A56 1
For the SF-D21
(The initial paper size setting is A4 for the AB system and 8 1/2 x 11
for the inch system.)
17. Pull out the large-capacity paper cassette.
Lift up on the handle on the paper cassette and pull the cassette out
from the desk until it stops (the paper loading position), and then lift
up on the casette handle once again and pull the cassette all the way
out of the desk.
18. Adjust the positions of the front and rear paper
guides.
Remove the mounting screws which secure the front and rear paper
guides, fit the two paper guides into the appropriate positions cor-
responding to the desired paper size, and then also secure the
mounting screws into the holes corresponding to the desired paper
size.
Rear paper guide
5 – 33
READY
SF-D20/D21 4 Sorter
Front paper guide
10