Adjust The Positions Of The Front And Rear Side Plates - Sharp SF-2030 Service Manual

10. Adjust the positions of the front and rear side
plates.
Remove the mounting screws (two each) which secure the front and
rear side plates, fit the two side plates into the appropriate positions
marked on the cassette corresponding to the desired paper size, and
then secure the side plates once again with the mounting screws (two
each).
Rear side plate
Front side plate
Screws
11. Adjust the position of the rear edge plate.
Remove the rear edge plate and fit it into the cassette at the position
corresponding to the desired paper size.
Rear edge plate
12. Set the paper size detection spacer.
Change the position of the paper size detection spacer to the position
corresponding to the desired paper size.
Paper size delection spacer
(Example: Position for A3 size paper)
Paper size detection spacer position diagram
Screws
13. Change the paper size indicator.
Remove the paper size indicator and re-insert it so that the paper size
for which the cassette has been set is visible in the paper size indica-
tion window.
Note that paper size indications are printed on both sides of the paper
size indicator.
5 – 32
AB system
A3
A4
A4R
A5
B4
B5
B5R
EXTRA
Inch system
8 1/2 x 14
8 1/2 x 11
8 1/2 x 11R
11 x 17
EXTRA
Paper size indicator