Set The Paper Size Detection Spacer - Sharp SF-2030 Service Manual

10. Set the paper size detection spacer.

Change the position of the paper size detection spacer to match the
desired paper size.
Paper size detection spacer position diagram
AB system
A3
A4
A4R
A5
B4
B5
B5R
EXTRA
Inch system
8 1/2 x 14
8 1/2 x 11
8 1/2 x 11R
11 x 17
EXTRA
11. Change the paper size indicator.
Remove the paper size indicator and reinsert it to show the paper
size for which the cassette has been set in the paper size indicator
window.
Note that paper sizes are printed on both sides of the paper size
indicator.
Paper size detection spacer
Example:A3setting
Paper size indicator
12. Fit the paper cassette guides into the guide
rails.
Insert the paper cassette by fitting the guides of the paper cassette
into the guide rails.
When doing this, insert the paper cassette all the way in so that the
cassette's left guide roller goes past the stopper on the guide rail.
Stopper
13. Mount the right stopper.
Fit the right stopper into the notch in front of the paper cassette's right
guide roller as shown in the figure.
When doing this, confirm that the right side of the paper cassette is
locked.
Pight stopper
14. Install the paper cassette.
Lift the rear sides of the paper cassette and insert the both sides of
guides into the Copier by fitting them to the guide rails as shown in
the figure. Make sure that the paper cassette slides smoothly.
Guide rail
Guide
5 – 42
Guide rails
1
Guide
2
Notch
Guide rail
Guide