Mount The Stopper - Sharp SF-2030 Service Manual

8. Mount the stopper.

Mount the felt washer to the stopper screw and secure the screw to
the sorter seat shaft.
Shaft
Felt washer
Stopper screw
9. Remove the sorter's front cabinet panel.
Remove the front cabinet panel screw.
Next, using a screwdriver, pry open the lower part of the front cabinet
panel to pull the lowest tab from the slot in which it is anchored.
Pull the front cabinet panel slightly up and out to remove it.
Disconnect the connector which is plugged into the front cabinet
panel.
Connector
Tab
Front cabinet panel
Tab
Straight-edge screwdriver
Front cabinet panel screw
10. Attach the sorter to the sorter seat.
Install the M4 x 8 sorter securing screws (2 pcs.) in the screw holes
on the sorter to attach the sorter to the sorter seat.
Sorter
11. Mount the sorter's front cabinet panel.
Plug the connector from the sorter into the circuit board inside the
sorter's front cabinet panel.
Fit the tabs on the left side of the front cabinet panel behind the ribs
on the sorter, and slide the tabs on the right-hand side of the front
cabinet panel behind the ribs in the sorter.
Check to be sure the tabs are securely positioned behind the ribs and
inserted properly into the slot.
Secure the front cabinet panel using the screw which was removed in
step 9.
Circuit board
Tab
Front cabinet panel
Tab
5 – 26
Slide rail
Sorter securing screws
(M4 x 8)
Connector
Tab
Front cabinet panel screw
Lock lever
Ribs