Fixed Glass Assembly; Grilles And Trim - Heat & Glo CERONA-36 Owner's Manual

STEP 7.
LOG #6 (SRV2107-706):
Place notch of log #6 over the left grate
tine. Log should rest on the fl at of log #5
and the fl at on log #3. You may need to
reposition log #5 to get log #6 to sit in the
fl ats. See Figure 7.
H. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
Pull the four glass assembly latches out of the groove on
the glass frame. Remove glass door from the appliance
(see Figure 14.2).
Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 14.2 Glass Assembly
Figure 7
Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. W • 9/15
6 6
I. Grilles and Trim
Install optional marble and brass trim surround kits as de-
sired. Marble, brass, brick, tile, or other noncombustible
materials can be used to cover up the gap between the
sheet rock and the appliance.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that the
bottom grille can be lowered and the trim door removed.
55