Install Support Brackets - Heat & Glo CERONA-36 Owner's Manual

• If the combustible materials are not in place at the time
of install the elbow heat shield may be screwed to the
exhaust pipe (see Figure 7.7). Cut the tabs as shown
and bend down. Secure the heat shield to the pipe
maintaining 3 inch to 4 inch between the pipe and shield.
SCREW
3 in.
(76 mm)
Figure 7.7
Refer to Cinch Pipe and Termination Cap installation in-
structions.
• Continue adding vent components, locking each
succeeding component into place.
• Ensure that each succeeding vent component is securely
fi tted and locked into the preceding component in the
vent system.
• 90º elbows may be installed and rotated to any point
around the preceding component's vertical axis. If an
elbow does not end up in a locked position with the
preceding component, attach with a minimum of two (2)
sheet metal screws.
26 Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. W • 9/15
F. Install Support Brackets
Refer to Cinch Pipe and Termination Cap installation in-
structions.