Installing Non-Combustible Facing Material - Heat & Glo CERONA-36 Owner's Manual

• Place the appliance into position.
• Level the appliance from side to side and front to back.
• Shim the appliance, as necessary. It is acceptable to use
wood shims.
• Bend out nailing tabs on each side.
• Keep nailing tabs fl ush with the framing.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
WARNING! Fire Risk. Maintain specifi ed clearances
around the appliance. DO NOT notch into the framing
around the appliance spacers.
C. Installing Non-combustible Facing Material
WARNING
Fire Risk.
• Follow these instructions exactly.
• Facing materials must be installed properly to
prevent fi re.
• No materials may be substituted without
authorization by Hearth & Home Technologies.
• Center and attach top board to the framing members
(see Figure 9.3).
• Use fasteners from fastener packet (in manual bag) in
shaded areas (Figure 9.3).
• Use regular sheetrock screws in non-shaded areas (see
Figure 9.3).
APPLY
FASTENERS FROM
FASTENER PACKET
IN SHADED AREAS
Figure 9.3 Attaching Non-combustible Facing Material
34 Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. W • 9/15
• Attach the left and right side pieces to the framing
members. (See Figure 9.3).
NON-COMBUSTIBLE
FACING MATERIAL
1 in.
(25 mm)
Cerona-36
Cerona-42
Figure 9.4 Complete Installation of Non-combustible
Facing Material
• Use a wet or dry towel or soft brush to remove dust or
dirt from facing material.
• Apply a non-combustible adhesive to attach tile,
stone or other non-combustible fi nishing materials per
manufacturer's instructions.
B
A
A B
in. 43-5/8 50-3/16
mm 1108 1275
in. 50-5/8 54-3/8
mm 1286 1381