Install Horizontal Termination Cap - Heat & Glo CERONA-36 Owner's Manual

J. Install Horizontal Termination Cap
WARNING! Risk of Fire! The telescoping fl ue section of
the termination cap MUST be used when connecting vent.
• 1-1/2 (38 mm) minimum overlap of fl ue telescoping
section is required.
Failure to maintain overlap may cause overheating and
fi re.
• Vent termination must not be recessed in the wall. Siding
may be brought to the edge of the cap base.
• Flash and seal as appropriate for siding material at
outside edges of cap.
• When installing a horizontal termination cap, follow
the cap location guidelines as prescribed by current
ANSI Z223.1 and CAN/CGA-B149 installation codes
and refer to Section 6 of this manual.
CAUTION! Risk of Burns! Local codes may require in-
stallation of a cap shield to prevent anything or anyone
from touching the hot cap.
Note: When using termination caps with factory-supplied
heat shield attached, no additional wall shield fi restop is
required on the exterior side of a combustible wall.
HEAT SHIELD OR
HEAT SHIELD
WALL SHIELD
FIRESTOP
CAN BE EXTENDED
INNER VENT
OUTER VENT
VENT DEPTH FROM BACK OF APPLIANCE TO
OUTSIDE SURFACE OF EXTERIOR WALL
(SEE CHART BELOW)
Figure 10.17 Venting through the wall
Cap Specifi cation Chart
(depth without using additional pipe sections)
DVP-TRAPK1 DVP-TRAP1
Top Vent Rear Vent
Depth
2-1/2 in. to
4-3/8 in.
Cerona-36
Cerona-42
DVP-HPC1 DVP-HPC1
Top Vent Rear Vent
Depth
2-1/2 in. to
4-5/8 in.
DVP-TRAP1 can adjust 1-1/2 in. (3-1/8 to 4-5/8)
DVP-TRAP2 can adjust 4 in. (5-3/8 to 9-3/8)
DVP-HPC1 can adjust 2-1/8 in. (4-1/4 to 6-3/8)
DVP-HPC2 can adjust 4-1/8 in. (6-3/8 to 10-1/2)
HEAT SHIELD
EXTENDED
1-1/2 IN. (38 MM) MIN.
OVERLAP
SLIP SECTION
SHEATHING
INTERIOR EXTERIOR
DVP-TRAPK2 DVP-TRAP2
Top Vent Rear Vent
Depth Depth Depth
N/A 5 in. to 9 in. N/A
DVP-HPC2 DVP-HPC2
Top Vent Rear Vent
Depth Depth Depth
4-3/4 in. to
N/A N/A
8-7/8 in.
Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. W • 9/15 41