Mercedes-Benz 2010 CL-Class Operator's Manual page 80

216_AKB; 3; 90, en-US
d2ureepe,
COMAND introduction
78
necessary to adapt the audio format
( Y page 172).
By selecting Logic7
i
formats are played back as they are
present on the medium. Due to the design
of the passenger compartment, an
optimum audio experience cannot be
guaranteed for all passengers.
Adjusting 3-D sound
With 3-D sound, you can choose between
®
Logic7 ON and Logic7
X
Select Sound Q 3D Sound.
Current setting
:
X
Selecting a setting: Slide
cVd.
X
Saving setting: Press W.
The setting is saved and the menu is closed.
X
Exiting menu without saving changes:
Press back button % or slide XVY.
Please note the following:
i
For an ideal sound experience in all
R
seats, the balance and fader should be
adjusted to the center of the passenger
compartment with Logic 7
The best sound results are achieved by
R
playing high-quality audio and video
DVDs.
For MP3 tracks, the bit rate should be at
R
least 128 kbit/s.
®
OFF, all compatible
®
OFF.
Switching the audio/video source off/
on
i
Active audio source
X
X
or
or rotate
ZVÆ
X
or
X
Active video source
X
®
switched on.
X
or
X
2009-05-15T11:47:50+02:00 - Seite 78
Version: 2.11.8.1
3-D sound does not work for mono-signal
R
sources, such as on analog AM radio or
in Weather Band.
In the event of poor radio reception
R
quality, e.g. inside a tunnel, you should
®
switch off Logic 7 , as a dynamic switch
from Stereo to Mono could occur,
resulting in temporary sound distortion.
With some stereo recordings, the
R
resulting sound may deviate from
conventional stereo playback.
When you load a CD or DVD, the audio or
video source is activated automatically.
Switching off: Select Audio Q Audio
OFF.
Playback is paused and the audio source is
switched off; Audio OFF appears in the
COMAND display.
Switching on: Select Audio, then the
desired audio source.
Load a CD/DVD ( Y page 165) or an SD
card ( Y page 166).
Connect a USB storage device
( Y page 72) or media interface device
( Y page 183) to COMAND.
Switching off: Select Video Q Video
OFF.
The audio source is switched off; Video
OFF appears in the COMAND display.
Switching on: Select Video, then the
desired video source.
Load a DVD ( Y page 165).