Mercedes-Benz 2010 CL-Class Operator's Manual page 224

216_AKB; 3; 90, en-US
d2ureepe,
Voice Control System navigation
222
Select POIs in your vicinity
With following commands you can select POIs
in your vicinity:
"Next gas station"
R
"Next parking lot"
R
"Next Mercedes-Benz service center"
R
"Next restaurant"
R
"Next hospital"
R
Sample dialog:
\ Next gas station.
_ The system shows a numbered list of
gas stations on the COMAND display.
^ Please select a line number.
\ Number one.
^ Number one accepted.
^ Do you want to start route guidance?
\ Yes.
The system calculates the route and, upon
completing route calculation, starts route
guidance.
"Last destinations"
Use the command "Last destinations" to
select a destination from among a number of
destinations last navigated to.
"Save destination"
Use the command "Save destination" to save
the current destination in the address book.
i The Voice Control System may recognize
names even if not saved in your voice. For
best possible call-up performance,
however, you should speak and save the
names you intend to use yourself.
If an entry is already available in the
address book, the system will ask you if you
would like to add the address to the
available entry.
2009-05-15T11:47:50+02:00 - Seite 222
Version: 2.11.8.1
Sample dialog:
\ Save destination.
^ Please say the name.
\ John Smith.
^ Please repeat the name.
\ John Smith.
^ Where do you want to save: home or
work?
\ Work.
^ The destination has been saved.
"Find address"
Use the command "Find address" to call up
an address from memory and to start route
guidance.
"Navigate (to) <voice name>" (address
book)
Use the command "Navigate (to) <voice
name>" to start route guidance by selecting
voice name with a saved destination address
from the COMAND address book.
A voice name may have two different
destination addresses associated with it
(home or work).
The system confirms your command,
calculates the route, and begins route
guidance. If only one address is stored, you
can use the command "Navigate (to) <voice
name>" to select the stored destination
address for that name.
If two addresses are stored, you can use the
commands
"Navigate (to) <voice name> home"
R
or
"Navigate (to) <voice name> work"
R
to directly select between home or work
address for that name. The system
confirms your selection, calculates the
route, and begins route guidance.
i
You can also navigate to address book
entries without voice names.