Mercedes-Benz 2010 CL-Class Operator's Manual page 265

216_AKB; 3; 90, en-US
d2ureepe,
then insert the SmartKey into the starter
switch.
i
The KEYLESS-GO start/stop button does
not need to be removed from the starter
switch when you leave the vehicle.
However, always take the SmartKey with
you when you leave the vehicle. As long as
the SmartKey is in the vehicle, the vehicle's
electrical systems can be switched on or
the engine can be started using the
KEYLESS-GO start/stop button.
KEYLESS-GO start/stop button
:
Starter switch
;
X
Insert the KEYLESS-GO start/stop button
into the starter switch (if not inserted
already).
i Allow for 2 seconds until the system has
detected the KEYLESS-GO start/stop
button.
X
Make sure the automatic transmission is in
park position P.
X
Do not depress the brake pedal.
2009-05-15T11:47:50+02:00 - Seite 263
Version: 2.11.8.1
Starter switch positions
KEYLESS-GO start/stop button
USA only
=
Canada only
?
Position 0
Before you press the KEYLESS-GO start/stop
button, the vehicle's on-board electronics
have status 0 (as with SmartKey removed).
Position 1
X
Press the KEYLESS-GO start/stop button
once.
This supplies power for some electrical
consumers, e.g. wipers.
i When you now open the driver's door, the
power supply is switched off.
Ignition (or position 2)
X
Press the KEYLESS-GO start/stop button
twice.
This supplies power for all electrical
consumers.
When you switch on the ignition, all lamps
in the instrument cluster come on. The
high-beam headlamp indicator lamp and
turn signal indicator lamps will only come
on if activated. If a lamp in the instrument
cluster fails to come on when the ignition
is switched on, have it checked and
replaced if necessary. If a lamp in the
instrument cluster remains on after
starting the engine or comes on while
driving, refer to "Lamps in instrument
Y
cluster" ( page 450).
263
Z