Stopping; Distronic Plus - Mercedes-Benz 2010 CL-Class Operator's Manual

216_AKB; 3; 90, en-US
d2ureepe,

Stopping

G
Warning!
The braking effect of the DISTRONIC PLUS is
canceled and the vehicle can start to roll if
the DISTRONIC PLUS is switched off using
R
the DISTRONIC PLUS lever
you accelerate
R
the DISTRONIC PLUS system or the power
R
supply is malfunctioning, e.g. due to battery
failure
the electrical components in the engine
R
compartment or the fuses have been
manipulated
the battery is disconnected
R
G
Warning!
Never get out of the vehicle while the
DISTRONIC PLUS is switched on!
The DISTRONIC PLUS must never be operated
or switched off by passengers or from outside
the vehicle.
The DISTRONIC PLUS is not a substitute for
the electronic parking brake. It must not be
used to secure the vehicle when parking.
When you get out of the vehicle or switch off
the engine, deactivate the DISTRONIC PLUS
and secure the vehicle from rolling away by
engaging the electronic parking brake.
When the DISTRONIC PLUS detects that the
preceding vehicle is stopping, the vehicle
brakes until it also stops. Once the vehicle is
at a standstill, it remains stationary, without
depressing the brake pedal.
After a short while, the vehicle is secured in
place by the electronic parking brake so that
the operating brake can be relieved of load.
Depending on the following distance set
using the distance setting switch on the
DISTRONIC PLUS lever (
vehicle will stop adequate away from the
preceding vehicle.
When the DISTRONIC PLUS is activated and
the vehicle is at a standstill, the automatic
transmission shifts into park position P
automatically when
R
R
R
R
R
The DISTRONIC PLUS is deactivated.
Setting the current speed
X
X
X
i
Changing the set speed
G
Keep in mind that it may take a brief moment
until the vehicle has made the necessary
adjustments.
Increase or decrease the set vehicle speed to
a value that the prevailing road conditions and
legal speed limits permit. Otherwise, sudden
Y page 313), the
and unexpected acceleration or deceleration
of the vehicle could cause an accident and/
or serious injury to you and others.
2009-05-15T11:47:50+02:00 - Seite 311
Version: 2.11.8.1
Driving systems
opening the driver's door and releasing the
seat belt
turning off the engine
opening the hood
a system malfunction occurs
the on-board voltage is insufficient
Accelerate or decelerate to the desired
speed.
Briefly lift the DISTRONIC PLUS lever in
direction of arrow : or depress in
direction of arrow ; ( Y
The current speed is set.
Remove your foot from the accelerator
pedal.
If you do not take your foot off of the
accelerator pedal and continue to
accelerate past the set speed, the following
message will appear in the multifunction
display:
DISTRONIC PLUS Override
The distance to a slower moving vehicle in
front of you will not be set. Your vehicle
speed will then be determined only by the
accelerator pedal position.
Warning!
311
page 309).
Z