Removing the Cable Manager Before Installing the SRX5800 Services Gateway Chassis
Copyright © 2014, Juniper Networks, Inc.
Figure 31: Removing a Power Supply Before Installing the Services
Gateway (Standard-Capacity Power Supply Shown, High-Capacity
Similar)
To remove the cable manager (see
Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
1.
ESD points on the chassis.
Using a 7/16-in. nut driver, unscrew the nuts on the corners of the cable manager.
2.
Grasp the bottom of the cable manager and pull it straight out from the studs on the
3.
front of the chassis.
Chapter 7: Installing the SRX5800 Services Gateway
Figure 32 on page
72):
71