Modules - Juniper SRX5800 Hardware Manual

Related
Documentation
Connecting Network Cables to SRX5800 Services Gateway IOCs and Port Modules
Copyright © 2014, Juniper Networks, Inc.
Figure 47: Connecting an External Alarm-Reporting Device
Attach the other end of the wires to the external device.
4.
To attach a reporting device for the other kind of alarm, repeat the procedure.
Overview of Installing the SRX5800 Services Gateway on page 47
SRX5800 Services Gateway Craft Interface Alarm Relay Contacts on page 26
Tools and Parts Required for SRX5800 Services Gateway Connections on page 87
Connecting the SRX5800 Services Gateway to a Network for Out-of-Band Management
on page 88
Connecting the SRX5800 Services Gateway to a Management Console or an Auxiliary
Device on page 89
Connecting Network Cables to SRX5800 Services Gateway IOCs and Port Modules
on page 91
Alarm Relay Contact Wire Specifications for the SRX5800 Services Gateway on page 298
To connect the IOCs, MPCs, and port modules to the network (see
Have ready a length of the type of cable used by the component.
1.
Remove the rubber safety plug from the cable connector port.
2.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Chapter 8: Connecting the SRX5800 Services Gateway
Figure 48 on page 93):
91