Table of Contents
Advertisement
42
Alliance System
User Manual
3d. There is a faulty condition due to cable
tamper. The cabling to the zone shows a
SHORT circuit (Figure 49).
Note:
operation only. If a zone is active, open, or
short the keypad emits a continuous tone.
When the status of the zone is changed to
normal, the display is updated and the
tone stops.
4. Press ENTER to exit and return to the menu
option display.
System menu option 13, Start auto disarm test
Use this menu to start the disarm test.
Start the auto disarm test
To start the auto disarm test, do the following:
1. Press MENU* (Figure 1), enter your user PIN code, and press ENTER (Figure 1).
2. Enter 13 (for menu 13) and press ENTER. The display shows the start auto disarm test window.
3. Press ON/NEXT (Figure 1) to display the untested zones.
Or
Enter 0 and press ENTER to cancel the disarm test and move to the test completed/not completed
displays.
4. If you pressed ON/NEXT the untested zones
will be displayed either one at a time
(Figure 50) or as a list.If you pressed ON/
NEXT the untested zones will be displayed
either one at a time (Figure 50) or as a list
(Figure 51).
Steps 2c and 2d are for dual zone
Figure 49. Cable tampering, short
SHORT on 12, Roller Door
Press ENTER
Figure 50. Untested auto disarm test one at a time
Untested Disarm On 4, PIR in Office
NEXT or ENTER
Figure 51. Untested auto disarm as a list
Untested On 1, 2, 4
Zone No:
Advertisement
Table of Contents
