Start Mode; Counting Speed; Supervisor Menu 2/2; Screen Saver - Talaris ntegra 177-0800 User Manual

Ntegra
On pressing the ESC/CLR to exit and save, the selected language will be used.
5.1.8

Start Mode

Press the 8 key on the numeric keys to toggle between AUTO and MANUAL start
modes.
If the manual start mode has been selected, the Ntegra will only start a count
when the START/STOP ( ENTER ) key is pressed.
In manual start mode, pressing the START/STOP ( ENTER ) key during a count
will force the Ntegra to stop.
5.1.9

Counting Speed

This feature allows the User to set the Ntegra to a specific counting speed for
each counting mode, within the allowable speed range for the mode.
Ensure that the Ntegra is in the operating mode for which the speed is to be set.
Press the 9 key on the numeric keys to toggle through the available speeds for
the operating mode.
5.2

Supervisor menu 2/2

5.2.1

Screen Saver

This feature allows a screen saver, either the default image or a pre-loaded 'user'
image, to be enabled, and to set the time delay between the last Ntegra activity,
either counting or a key press, to the screen saver image being displayed.
Contact your local Talaris distributor for further information on creating
and installing a 'user' image.
TP05413021 Interim
Counting Speeds
Operating Available
Mode Speeds
Count 1000 npm
1200 npm
1300 npm
1500 npm
Mix 1000 npm
1200 npm
Single 1000 npm
1200 npm
Face 1000 npm
1200 npm
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
Operating Available
Mode Speeds
Orient 1000 npm
1200 npm
Fit 600 npm
700 npm
800 npm
Serial 500 npm
Bar 1000 npm
1200 npm
1300 npm
1500 npm
Note:
Functions
Page 45 of 56