Mode Selection; Start Mode; Counting Speed; Function Keys - Talaris ntegra 177-0800 User Manual

Ntegra
Use the UP or DOWN navigation keys to move the arrow to the required currency.
Press the CENTRE key to select the currency.
The currency name and symbol will change on the screen to indicate the selected
currency.
If the corresponding currency data table is not loaded in the Ntegra, all
notes will be sent to the reject pocket.
3.5

Mode Selection

Depending upon the model of Ntegra, the operating modes may include piece
Count, Mixed denomination value count, Single denomination value count, single
note facing ( Face ), single note orientation ( Orient ), Serial Number reading (
data transmits to printer if installed and enabled ), Fitness ( Fit ) sorting and Bar
code reading.
Press the "UP" navigation key to step through the available counting modes.
At each key press the Ntegra will change the mode name on the screen to the
next available mode.
3.6

Start Mode

The Start Mode is set in the Supervisor Functions. Refer to "Start Mode" on
page 45.
3.7

Counting Speed

The Counting Speed is set in the Supervisor Functions. Refer to "Counting
Speed" on page 45.
3.8

Function Keys

3.8.1

FUNC

Press the FUNC key to enter the Supervisors Set-Up menus. The Supervisors
set-up menu consists of two ( 2 ) pages. Use the RIGHT and LEFT navigation
keys to move between menu 1/2 and menu 2/2.
Refer to "Functions" on page 39 for full details on the available features.
3.8.2

ESC/CLR

Press the ESC/CLR key to exit set-up menus or to clear reject note counts, or
note counts in the ADD mode.
TP05413021 Interim
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
Operating / Set-up Instructions
Note:
Page 15 of 56