Ntegra
2.4
Feed Gap Adjustment
The feed gap is nominally 0.1mm with the adjustment control at the centre
position. To reduce the feed gap, rotate the adjustment control anti-clockwise to
the minus range. To increase the feed gap, rotate the adjustment control
clockwise to the plus range.
Adjust the feed gap by a half setting, then re-check the feed.
Feed gap adjustment is required for the following reasons:
• The counting of new or mint condition notes.
• The counting thin or poor condition notes.
• The counting of average condition notes.
TP05413021 Interim
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
Machine Overview
Page 7 of 56