[D-1] Deleting The Fault Codes; [D-2] Delete Function Test - Yamaha Vmax VMX17C 2009 Service Manual

EAS2S31075

[D-1] DELETING THE FAULT CODES

1. Connect the test coupler adapter "1" to the
ABS test coupler "2". Refer to "[B-5] MAL-
FUNCTION ARE CURRENTLY DETECT-
ED" on page 8-83.
2
1
2. Turn the main switch to "ON".
Fault codes will be displayed in the multi-
function display.
3. Set the engine stop switch "1" to "
ECA2S31055
NOTICE
If the start switch is pushed without setting
the engine stop switch to "
motor gears or other parts may be damaged.
4. Without operating the brake lever, push the
start switch "2" at least 10 times in 4 seconds
to delete the fault codes.
5. The multi-function display switches to the
odometer display and the ABS warning light
flashes in 0.5 second-intervals while the fault
codes are being deleted.
6. Turn the main switch to "OFF".
7. Turn the main switch to "ON" again.
TIP
If fault codes are still displayed in the multi-func-
tion display, the malfunctions have not been re-
paired. Diagnose the malfunctions using the
fault codes.
ABS (ANTI-LOCK BRAKE SYSTEM)
".
", the starter
1
2
8-114
8. Turn the main switch to "OFF".
9. Disconnect the test coupler adapter from the
ABS test coupler, and then install the protec-
tive cap onto the ABS test coupler. Deleting
the fault codes is now finished.
TIP
Do not forget to install the protective cap onto
the ABS test coupler.
ECA2S31056
NOTICE
Since the fault codes remain in the memory
of the ABS ECU until they are deleted, always
delete the fault codes after the service has
been completed.
EAS2S31076

[D-2] DELETE FUNCTION TEST

1. Place the vehicle on a suitable stand.
2. Turn the main switch to "OFF".
3. Connect the test coupler adapter to the ABS
test coupler.
4. Turn the main switch to "ON".
5. Check:
• ABS ECU voltage
Lower than 12.8 V → Charge or replace the
battery.
Battery voltage
Higher than 12.8 V
M MMM M MMM M M MMM M M MMM M
a. Connect the pocket tester (DC 20 V) to the
ABS ECU coupler.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
red/blue "1"
• Negative tester probe →
black/white "2"
B W Ch L/W W/Y
B/W
Lg/W B/L B W
B
Lg/L Y
2
M MMM M M MMM M MMM
Br/R
G/R
Br
L/W Ch G/Y R/L
1