Yamaha Vmax VMX17C 2009 Service Manual page 123

1. Clutch hose
2. Brake hose (hydraulic unit to left front brake
caliper)
3. Brake hose (front brake master cylinder to
hydraulic unit)
4. Brake hose (left front brake caliper to right front
brake caliper)
5. Front wheel sensor lead
6. Front right turn signal/position light lead
7. Front left turn signal/position light lead
A. Install the rubber damper so that the slits in the
damper are toward the front frame.
– –
B. 45 51 mm (1.77 2.01 in)
C. To hydraulic unit
– –
D. 0 3 mm (0 0.12 in)
E. Fasten the clutch hose with the holder on the oil
pipe 1.
F. Insert the projection on the holder into the hole in
the clutch hose holder bracket, and then fasten the
clutch hose with the holder. Face the catch of the
holder inward.
– –
G. 60 80 mm (2.36 3.15 in)
– –
H. 10 30 mm (0.39 1.18 in)
I. Fasten the front right turn signal/position light lead,
front left turn signal/position light lead, and
grommet on the brake hose (front brake master
cylinder to hydraulic unit) with the holder.
J. Face the catch of the holder rearward.
K. Fasten the front left turn signal/position light lead
to the brake hose and front left turn signal/position
light lead guide with plastic locking ties. Align the
plastic locking ties with the cutouts in the guide.
Cut off the excess end of each plastic locking tie to
– –
2 5 mm (0.08 0.20 in). The end of each plastic
locking tie may be pointing in any direction.
– –
L. 7 13 mm (0.28 0.51 in)
M. Route the front wheel sensor lead between the
brake hose guide and the front frame.
N. Fasten the front left turn signal/position light lead
with a plastic locking tie. Position the plastic locking
tie under the bent portion of the brake hose and
front left turn signal/position light lead guide.
O. Point the end of the plastic locking tie to the left,
and then cut off the excess end of the tie to 2
–
mm (0.08 0.20 in).
–
5
2-70
CABLE ROUTING