Yamaha Vmax VMX17C 2009 Service Manual page 103

1. Throttle cables
2. Brake hose (front brake master cylinder to
hydraulic unit)
3. Clutch hose
4. Meter assembly 1
5. Left handlebar switch lead
6. Meter assembly 1 lead
7. Headlight coupler
8. Auxiliary light coupler
A. Route the throttle cables as shown in the
illustration. When installing the headlight, make
sure that the cables are not pinched.
B. Route the brake hose (front brake master cylinder
to hydraulic unit) as shown in the illustration. When
installing the headlight, make sure that the hose is
not pinched.
C. Route the meter assembly 1 lead through the
opening in the headlight top cover.
D. Route the clutch hose as shown in the illustration.
When installing the headlight, make sure that the
hose is not pinched.
E. Route the left handlebar switch lead as shown in
the illustration. When installing the headlight, make
sure that the lead is not pinched. Route the right
handlebar switch lead in the same way on the right
side of the vehicle.
F. Forward
G. Fasten the meter assembly 1 lead at the
positioning tape with a plastic locking tie.
H. Position the buckle of the plastic locking tie under
the lead with its end pointing inward as shown in
the illustration. Cut off the excess end of the plastic
–
locking tie to 2 5 mm (0.08
I. Down
–
0.20 in).
2-50
CABLE ROUTING