Yamaha Vmax VMX17C 2009 Service Manual page 216

L LLL L LLL L L LLL L L LLL L
3. Install:
• Brake hose gaskets
• Brake hose (hydraulic unit to rear brake cali-
per) "1"
• Brake hose union bolt "2"
Brake hose union bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
EWA13530
WARNING
Proper brake hose routing is essential to in-
sure safe vehicle operation. Refer to "CABLE
ROUTING" on page 2-47.
ECA2S31023
NOTICE
When installing the brake hose onto the
brake caliper, make sure the brake pipe "a"
touches the projection "b" on the brake cali-
per.
4. Install:
• Brake pad supports
• Brake pad insulator
(onto the left brake pad)
• Brake pad shims
(onto the brake pads)
• Brake pads
• Brake caliper retaining bolts
• Rear brake caliper
Refer to "REPLACING THE REAR BRAKE
PADS" on page 4-47.
4
3
L LLL L L LLL L LLL
New
1
a
b
2
• Rear wheel sensor lead holder
Brake caliper retaining bolt
27 Nm (2.7 m·kgf, 19 ft·lbf)
Rear wheel sensor lead holder
bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
5. Fill:
• Brake fluid reservoir
(with the specified amount of the recom-
mended brake fluid)
Recommended fluid
DOT 4
EWA13090
WARNING
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake fluids
may result in a harmful chemical reaction,
leading to poor brake performance.
• When refilling, be careful that water does
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor lock.
ECA13540
NOTICE
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
6. Bleed:
• Brake system
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM (ABS)" on page 3-24.
7. Check:
• Brake fluid level
Below the minimum level mark "a" → Add the
recommended brake fluid to the proper level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-22.
4-51
REAR BRAKE