Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel (Rear Brake Disc) - Yamaha Vmax VMX17C 2009 Service Manual

b
6. Measure:
• Wheel sensor rotor deflection
Out of specification → Correct the wheel sen-
sor rotor deflection or replace the wheel sen-
sor rotor.
Refer to "MAINTENANCE OF THE REAR
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-24.
Wheel sensor rotor deflection
limit
0.14 mm (0.0055 in)
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-17.
EAS22170
INSTALLING THE REAR WHEEL (REAR
BRAKE DISC)
1. Install:
• Rear brake disc
• Rear brake disc cover
Rear brake disc bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
LOCTITE®
TIP
Tighten the brake disc bolts in stages and in a
crisscross pattern.
a
b
1
2
4-26
2. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-47.
3. Lubricate:
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
4. Install:
• Rear wheel sensor housing
• Rear wheel
• Rear brake caliper bracket
• Rear wheel axle
TIP
• Do not install the brake pad supports, brake
pads, brake pad insulator, brake pad shims,
and brake caliper.
• Align the slot "a" of the rear wheel sensor hous-
ing "1" with the projection "b" of the rear brake
caliper bracket "2", and then assemble them.
• Fit the brake torque stop pin "3" on the swing-
arm into the slot "c" on the rear brake caliper
bracket.
• After assembling the rear wheel sensor hous-
ing and the rear brake caliper bracket, make
sure that the projection "d" on the housing is
aligned with the projection "e" on the bracket.
ECA14470
NOTICE
Make sure there are no foreign materials in
the wheel hub. Foreign materials cause dam-
age to the inner sensor rotor and wheel sen-
sor.
REAR WHEEL