Command Description - Raritan PX3TS Quick Setup Manual

Whether to Use this command
Make the network wireless
allowConnectionWithIncorrectClock
connection
<option3>
successful by
ignoring the
"incorrect"
system time
<option3> = true or false
d. To determine which IP protocol (IPv4 or IPv6) is
enabled and which IP address (IPv4 or IPv6) returned
by the DNS server is used, configure the following
parameters.
To set Use this command
IP protocol network ip proto <protocol>
<protocol> = v4Only, v6Only or both
IP address network ip dnsResolverPreference
returned by the <resolver>
DNS server
<resolver> = preferV4 or preferV6
e. After enabling the IPv4 or IPv6 protocol in the earlier
step, configure the IPv4 or IPv6 network parameters.
To set Use this command
IPv4 network ipv4 ipConfigurationMode
configuration <mode>
method
<mode> = dhcp (default) or static
IPv6 network ipv6 ipConfigurationMode
configuration <mode>
method
<mode> = automatic (default) or static
 Configure the preferred host name for the IPv4
DHCP or IPv6 automatic configuration.
Note: The <version> variable in all of the following
commands is either ipv4 or ipv6, depending on the type
of the IP protocol you have enabled.
To set Use this command
Preferred host network <version>
preferredHostName <name>
name (optional)
<name> = preferred host name
PX3TS Transfer Switch Quick Setup Guide
QSG-PX3TS-0D-v3.1-E  255-80-0032-00 RoHS
Tip: To override the DHCP-assigned DNS servers with
those you specify manually, type this command:
network <version> overrideDNS <option>
where <option> is enable or disable. See the table
below for the commands for manually specifying DNS
servers.
For static IP configuration, configure these

parameters.
To set Use this command
Static IPv4 or network <version> ipAddress <ip
IPv6 address address>
<ip address> = static IP address
IPv4 subnet network ipv4 subnetMask <netmask>
mask
<netmask> = subnet mask
IPv4 or IPv6 network <version> gateway <ip
gateway address>
<ip address> = gateway's IP address
IPv4 or IPv6 network <version>
primaryDNSServer <ip address>
primary DNS
server
<ip address> = IP address of the primary
DNS server
IPv4 or IPv6 network <version>
secondaryDNSServer <ip address>
secondary DNS
server (optional)
<ip address> = IP address of the
secondary DNS server
9. To quit the configuration mode, type either of the following
commands, and press Enter.
Command Description
apply Save all configuration changes and exit.
cancel Abort all configuration changes and exit.
The # prompt appears, indicating that you have quit the
configuration mode.
10. To verify whether all settings are correct, type the
following commands one by one.
Command
show network
show network ip all
Description
Show network parameters.
Show all IP configuration
parameters.
9