Command Description - Raritan Dominion PX Quick Setup Manual

where <option> is enable or disable. See the table
below for the IPv6 commands for manually specifying DNS
servers.
 For the static IPv6 configuration, you should
configure the following parameters. Note that the IP
address must follow the IPv6 format.
To set Use this command
Static IPv6 network ipv6 ipAddress <ip
address>
address
where <ip address> is the IP address you
want to assign.
Gateway network ipv6 gateway <ip address>
where <ip address> is the IP address of the
gateway.
Primary DNS network ipv6 primaryDNSServer <ip
address>
server
where <ip address> is the IP address of the
primary DNS server.
Secondary DNS network ipv6 secondaryDNSServer
<ip address>
server (optional)
where <ip address> is the IP address of the
secondary DNS server.
9. To quit the configuration mode with or without saving the
changes, type either command, and press Enter.
Command Description
apply Save all configuration changes and quit the
configuration mode.
cancel Abort all configuration changes and quit the
configuration mode.
The # prompt appears, indicating that you have quit the
configuration mode.
10. To verify whether all settings are correct, type the following
commands one by one. Current network settings are
displayed.
Command
show network
Dominion PX Quick Setup Guide
QSG-DPX2-0F-v2.2-E  255-80-6099-00 RoHS
Description
Show network parameters.
Command
show network ip all Show all IP configuration
show network
wireless details
Tip: You can also type "show network wireless" to
display a shortened version of wireless settings.
11. If all are correct, type exit to log out of Dominion PX. If any
are incorrect, repeat Steps 7 to 10 to change any network
settings.
QS Rule
What To Do Next
1. Connect IT equipment to the outlets on the Dominion PX.
2. From a computer connected to your LAN, open a browser
and point it at the IP address of the Dominion PX device.
3. When prompted for a user name and password, enter
admin and the new password you assigned during the
procedure titled Configuring Dominion PX
4. The Dominion PX page opens.
5. Choose Device Settings > Date/Time to configure
Dominion PX with the proper date and time or synchronize
it with an NTP server. Dominion PX's time must be in sync
with the LDAP server to use LDAP authentication.
Important: If you are using Raritan's Power IQ to manage
Dominion PX, you must configure Power IQ and Dominion
PX to use the same NTP servers.
6. Dominion PX is sent from the factory with all the outlets ON.
Turn OFF the outlets without devices connected from the
web interface.
7. Use the menu at the top of the page to create user profiles,
set privileges, set security, and configure outlet thresholds.
Note: Detailed instructions are available in the Dominion PX
User Guide.
QS Rule
MAC Address
A label is affixed to a Dominion PX device, near the LED
display, showing both the serial number and MAC address of
the PDU.
If necessary, you can find the PDU's IP address through the
MAC address by using commonly-used network tools. Contact
your LAN administrator for assistance.
Description
parameters.
Show all wireless parameters.
(Perform this command only when
you enable the wireless mode.)
(on page 7).
9