A Note About Group Commands; Set Power Set Delay Command; Get Power On Delay Command; Set Receptacle State Command - Raritan Dominion PX User Manual

Command Name
Test Actors
Test Sensors
Set Power Cycle Delay Command
Get Power Cycle Delay Command
Request Data 1
Response Data 1
Request Data -
Response Data 1
2
Id
0x1C
0x1D
0x1E
0x1F

A Note About Group Commands

When sending Group commands, a valid group number (0 through 23, or
255) must be used. Only the group number itself can be sent, alpha-
numeric expressions for group numbers are incorrect, and cause the
command to be ignored.
For example, sending the following is incorrect:
#ipmitool -H 192.168.80.43 -U admin -P pass raw 0x3c
0x14 grp2 0
Dominion PX will ignore this command.

Set Power Set Delay Command

The global power on delay defines how much time has to pass between
two power on actions.
delay in 1/10 seconds
the delay is the minimum time after which a receptacle will be switched
on after a previous receptacle has been switched on.
Completion Code

Get Power On Delay Command

-
Completion Code
delay in 1/10 seconds

Set Receptacle State Command

This command is used to switch on/off and recycle individual
receptacles.
Appendix D: Using the IPMI Tool Set
155