4.2.8
Enabling or Disabling the Appliance Mode
The Appliance mode allows your thin client to start up directly with the desired Microsoft Remote Desktop, Citrix
ICA, VMware View or Horizon View session. After existing a session, the client will be turned off.
NOTE
• There are two similar but different modes for your thin client:
• For more information on above modes, please refer to sections:
Enabling the Appliance Mode
To enable the Appliance mode, please do the following:
NOTE
• Ensure that you have configured the connection settings for the desired Microsoft
Remote Desktop, Citrix ICA, VMware View or Horizon View session under
Applications tab. You need to specify which service type and connection settings
entry will be used under the Appliance mode. For detailed instructions, please
see sections:
No.
Mode
Description
The client will start up directly with the desired
1
Appliance
RDP / ICA / View session and turn off after
existing the session.
The client will start up directly with the desired
RDP / ICA / View session and perform the
configured action after existing the session.
Available actions include:
2
Autostart
• Returning to the local desktop
• Re-launching a new session
• Restarting the thin client
• Turning off the thin client
section 4.2.8 on page 41 (Appliance mode)
section 4.5.5 on page 66 (Autostart mode for RDP sessions)
section 4.5.8 on page 94 (Autostart mode for ICA sessions)
section 4.5.11 on page 109 (Autostart mode for View sessions)
"4.5.3 Configuring Basic RDP Connection Settings" on page 54
"4.5.6 Configuring Basic ICA Connection Settings" on page 79
"4.5.9 Configuring Basic VMware View Connection Settings" on page 105
Configuring Client Settings
Configuring System Settings
41