ViewSonic SC-T47 User Manual page 22

Setting Up Your SC-T47
Positioning Your SC-T47
VESA-mounted
To mount your SC-T47, please follow the steps below:
1. Ensure that all rubber pads on the underside of your SC-T47 are removed from the pad holes and the pad /
VESA holes are clean without any blockage.
2. Align two mount holes on the VESA bracket with two mount holes on your SC-T47, and then secure the
bracket to your SC-T47 with two (2) screws as shown below.
3. Align the mount holes on the VESA bracket with the mount holes on the monitor, and then secure the
bracket and SC-T47 to the monitor with two (2) screws as shown. Ensure that your SC-T47 is located in the
center of the monitor and the rear panel of your SC-T47 is facing rightward as shown below.
12