Heating - Skoda Roomster Owner's Manual

Close air outlet vents 3 and 4
›
Turn the vertical wheel (air vents 3)
let nozzles 4) to the 0 position.
Change air flow of air outlet vents 3 and 4
›
In order to change the strength of the air flow, swivel the horizontal lamellas
with the aid of the moveable adjuster
›
In order to change the lateral direction of the air flow, swivel the vertical la-
mellas with the aid of the moveable adjuster.
Set the air supply to the individual vents with the air distribution control
» Fig. 98 on page 88.
C
Note
Do not cover the air outlet vents with objects of any kind.
Using the air conditioning system economically

Read and observe and
The air conditioning system compressor uses power from the engine when in
cooling mode, which will affect the fuel consumption.
It recommended to open the windows or the doors of a vehicle for which the
interior has been strongly heated through the effect of direct sunlight in order
to allow the heated air to escape.
The cooling system should not be switched on if the windows are open.
For the sake of the environment
Pollutant emissions are also lower when fuel is being saved
Operational problems

Read and observe and
If the cooling system does not operate at outside temperatures higher than +5
°C, there is a problem in the system. The reasons for this may be.
›
One of the fuses has blown. Check the fuse and replace if necessa-
ry » page 168.
›
The cooling system has switched off automatically for a short time because
the coolant temperature of the engine is too hot
88
Operation
» Fig. 97 or the horizontal wheel (air out-
» Fig. 97.
on page 87 first.
» page
on page 87 first.
» page 29.
If you are not able to resolve the operational problem yourself, or if the cooler
output has reduced, switch off the cooling system and seek assistance from a
specialist garage.

Heating


Introduction
This chapter contains information on the following subjects:
Operation
Setting
Recirculated air mode
Operation
110.
Fig. 98 Heating: Control elements
Functions of the individual controls
Set the temperature (turn to the left: to reduce the temperature, turn to
A
the right: to increase the temperature)
Set the blower level (level 0: blower off, level 4: the highest blower speed)
B
Set the direction of the air outlet
C
Switch recirculation on/off

Controls and
A
» Fig. 98:
» page 87
» page 89
» Fig. 98 can be set to any intermediate position.
C
88
89
89
