Skoda Roomster Owner's Manual page 125

Description
Fig. 120 Remove the cover cap: on the rear bumper / for the receiving
shaft

Read and observe and
The ball head can be removed and is kept in the spare wheel well or in a com-
partment for the spare wheel in the luggage compartment
tool kit.
Image description » Fig. 120 and
Clamps for removing the wheel trims
1
Cover in the rear bumper
2
13-pin power socket
3
Cover for the mounting recess
4
Dust cap
5
Ball head
6
Operating lever
7
Lock cap
8
Fig. 121
Ball head
on page 122 first.
» page
» Fig. 121
Release pin
9
Key
10
Locking ball
11
Note
The tool for removing the wheel trim is part of the vehicle tool
■
kit » page 159 .
If you lose the key, please get in touch with a specialist garage.
■
Adjusting the ready position
Fig. 122 Setting the ready position/ready position

Read and observe
Always adjust the ball head to the correct position before fitting.
›
Turn the key so that its red mark
›
Grip the ball head below the protective cap
›
Press the release pin
159, Vehicle
the same time push the lever
tion of the arrow.
The lever remains locked in this position.
CAUTION
In the ready position, the key cannot be removed nor turned to a different po-
sition.
and on page 122 first.
» Fig. 122 is visible.
1
.
2
as far as the stop in the direction of the arrow - at
3
downwards as far as it will go in the direc-
4
Towing a trailer
123