Cruise Control System - Skoda Roomster Owner's Manual

Hide thumbs Also See for Roomster:
Table of Contents

Advertisement

WARNING
The parking aid is not a substitute for the driver paying proper attention
and it is always the driver's responsibility to take care when reversing the
vehicle or carrying out similar manoeuvres. Pay particular attention to small
children and animals as they are not recognised by the parking aid sensors.
Before reversing, you should make sure that there are no small obstacles,
such as rocks, thin posts, trailer drawbars etc. behind your vehicle. Such ob-
stacles may not be recognised by the parking aid sensors.
Under certain circumstances, surfaces of certain objects and types of
clothing cannot reflect the system signals. Thus, these objects or people
who wear such clothing are not recognised by the System sensors.
External sound sources can have a detrimental effect on the system. Un-
der adverse conditions, this may cause objects or people to not be recog-
nised by the system.
CAUTION
If a warning signal sounds for about 3 seconds after activating the system
and there is no obstacle close to your car, this indicates a system fault. Have
the fault rectified by a specialist garage.
The sensors must be kept clean (free of ice, etc.) to enable the parking aid to
operate properly.
Under adverse weather conditions (heavy rain, water vapour, very low or
high temperatures etc.) system function may be limited.
Additionally installed modules such as bicycle carriers can impair the function
of the parking aid.
Function
118
Driving
Fig. 116
Parking aid: Range of sensors
Read and observe
and
The parking aid (referred to below solely as system) only works when the igni-
tion is switched on.
The system supports the driver via audible signals, via the display on the radio
or via the factory-installed navigation system when parking and manoeu-
vring
»
Radio user guide, Navigation system user guide.
The system uses ultrasound waves to calculate the distance between the
bumper and an obstacle. The ultrasonic sensors are integrated in the rear
bumper.
Range of sensors
The clearance warning begins at a distance of about 160 cm from the obstacle
(area
» Fig.
116). The interval between the warning signals becomes shorter
A
as the clearance is reduced.
A continuous tone sounds from a distance of approx. 30 cm (area
area. You should not reverse any further after this signal sounds!
On vehicles with a factory-fitted towing device, the border of the danger area
starts (continuous tone) 5 cm further away from the vehicle. The length of the
vehicle can be increased with an installed detachable towing device.
Activation/deactivation
Read and observe
and
The system is activated automatically by engaging reverse gear. This is con-
firmed by a brief audible signal.
The system is deactivated by disengaging reverse gear.
Note
The system cannot be activated on vehicles with a factory-fitted towing device
when towing a trailer.

Cruise Control System

Introduction
This chapter contains information on the following subjects:
Storing a speed
Changing a stored speed
on page 118 first.
on page 118 first.
) - danger
B
119
119

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents